Program Preparation Mode; Access Service Mode; Error Code Read Out; Actuator Test - Electrolux FGCD2456QW Technical & Service Manual

3.3 Program Presentation Mode
The Service mode shall only be accessible from
the Program Preparation Mode. The machine is in
the Program Preparation Mode when a program is
selected but not started.
If the machine is not in the Program Preparation
Mode, pressing the CANCEL button will bring the
machine into this mode.
Pressing the CANCEL button may start the 1-minute
draining cycle. If this happens, close the door and
wait. Open the door at the end of the draining cycle
and the machine will be in the Program Preparation
Mode.

3.4 Access Service Mode

In all models in the Durham range, the full function
Service Mode includes:
•

Error code read out

•

Actuator Test

• LED Test
• Functional Test Cycle
According to hardware configuration of the
dishwasher and the marketing requirements, Service
Mode may vary in individual models and can be a
subset of the above listed functions.
To access Service Mode, make sure the machine is in
the Program Preparation Mode, press and hold K1and
K3, simultaneously for at least 5 seconds. The LEDs
L1, L2 and L3 blinks to indicate the Service Mode is
accessed. All other LEDs and the display (if equipped)
are OFF.
Machine is now in the Service Menu Mode. This mode
can be exit by pressing the CANCEL button, or 60
seconds after the last button is pressed.
3.5 Error Code Read Out
After accessing the Service mode (L1, L2 and L3
blinking):
1. Press button K1 to show the first error code.
• L1 blinks to indicate the machine is in the Error
Code Reading Mode.
• The first error code saved in memory is
shown in the display if the model has a
display. If the model is not equipped with a
display, the error code is shown by the LEDs
L4 and L5. Details of the error code are listed
in the Error Codes section of this document.
2. Pressing button K1 again will show the second
error code.
3. Pressing button K1 once more will show the third
error code.
4. The Error Code Reading Mode shall exit by
pressing the CANCEL button or waiting 60
seconds after the last button is pressed.
3.6 Actuator Test
When the machine is in the Error Code Reading Mode
and showing the third error code, pressing K1 again
will switch the dishwasher into Actuator Test Mode.
1. Press button K1 for the fourth time to move into
the Actuator Test Mode. Pressing the button K1
repeatedly will sequentially activate one actuator
at a time.
• L1 will turn off. L2 will blink to indicate the
machine is in the Actuator Test Mode.
• The activated actuator number is shown in
the display, if the model has a display. If the
model is not equipped with a display, the
actuator number is shown by the number
of blinks of L4. For example, the actuator
number 5 will cause L4 to flash a total of 5
times, pause, then repeat this. The following
table provides the actuator details:
9