Electrolux FGCD2456QW Technical & Service Manual page 15

"i92" – code: checksum CCF
• The error is signalled if the configuration control of
the washing cycles provided erroneous results.
"i93" – code: checksum UIDATA
• The error is signalled if the configuration control
of the UI configuration data provided erroneous
results.
"i94" – code: UIDATA version
mismatch
• The error is signalled if the UIDATA provided in
configuration file mismatches the attached UI
board.
"i95" – code: UIDATA checksum
mismatch
• The error is signalled if the UIDATA checksum type
provided in configuration file mismatches with the
attached UI board.
"iB0" Code - family : Sensor
Problem
"iB0" - code: turbidity sensor
• The error is set if the calibration procedure is not
completed after 15 sec.
• The washing program will run as though the dirt
value to be considered is high
"iC0" Code - family:
Communication Problem
"iC0" – code: user interface
communication
• The error signal is displayed if the communication
system does not recognize any display board.
"iC1" – code: MACS bus
communication
• After three attempts to establish communication,
an error is signalled in the hardware control
"iC2" – Code: ADSI communication
• The washing programme is suspended but it can
be restarted if the error conditions no longer
apply
"iC3" – Code: Communication
between the power board and the
Motor Control Board
• The error is signalled if the communication
between the Motherboard and the Motor Control
Board does not start.
• Acoustic signal and visual error, depending on the
appliance customization; the washing program is
restarted automatically if the error conditions no
longer apply.
"iD0" Code - family: Tacho
Problem
"iD0" – code: no signal
• The error is stored and displayed only in service
mode; there is a new control for each new phase.
• If the washing pump is activated but there is no
tacho signal for 30 seconds then the motor speed
is set to full speed and the heating element is not
activated.
"iD1" – code: critical signal
• The error is stored and displayed only in service
mode.
• If the washing pump is activated but there is
no tacho signal for 5 seconds then the heating
element is temporarily deactivated. If after
another 30 seconds there is still no signal the
appliance displays an error code iD0.
15