Table of Contents
Advertisement
Getting started
Assembly
The telephone is packaged in dis-
mantled form and must be re-assem-
bled before use.
with a protective film. Remove this
film before getting started.
In rare cases, the static discharge
may cause discoloration at the edges
of the display. However, this will dis-
appear within approx. 10 minutes.
Place the keyboard mat
tion. Ensure that it is sitting accu-
rately in place.
1
Then place the faceplate
tion by pressing it lightly until it
clicks onto the telephone.
Your phone's
display and
the display
on the face-
plate are
delivered
1
in posi-
2
in posi-
Getting started
2
To remove the faceplate, insert the
pin on the battery cover in the open-
ing, press it lightly
4
the same time
4
CLIPit™ Covers
Before changing the keypad mat or face-
plate, switch the phone off.
The new keypad has an additional key
under the joystick to permit direct access to
the Internet information from the service
provider.
3
and turn it at
to open the lock.
3
15
Advertisement
Table of Contents
