Intercom Set Up - Raymarine Ray230 Owner's Handbook Manual

3-72

3.5.30.5.1 Intercom Set Up

The operation is identical to the Intercom operation described for the
RAY230 in section 3.5.30.4.1.
3.5.30.5.2 MY ATIS Set Up
This operation stores the ATIS number required for the Automatic
Transmission Identification System used in inland waterways of some
European countries. You can request an ATIS number when you apply for
a radio license.
Regulations in some regions may not allow end users to program their own
ATIS number. If this unit was purchased to be used in such a region, this
function will be disabled and the programming must be done by your
Raymarine distributor.
Notes:
• This is a one time operation. Once the ATIS number has been
programmed, you will not be able to change it.
• The ATIS ID number is a ten digit number, beginning with a "9". The
MY ATIS set up process has you input only the last 9 digits. The leading
"9" is automatically input for you.
To register the ATIS Number into memory:
1. Select the MY ATIS function as described above in Section 3.5.30.5
Setting Operation (RAY230E).
2. Press the ENT key. The 7-segment display shows AId and the dot
matrix display scrolls PLEASE PROGRAM ATIS ID.
3. Press ENT. Nine underscore characters appear, which are placeholders
for the last 9 digits of the ATIS number. The first character place to be
input is flashing.
Pressing the following keys initiate the corresponding operation:
Operations