Extended Systems; Using The Control Unit; Switching On And Off - Raymarine ST8002 Operating Manual

2
:
S1G, S2G and S3G systems
(with GyroPlus)
Internal GyroPlus yaw sensor provides
enhanced course keeping using AST
(Advanced Steering Technology)
Steering to true and apparent wind in
Wind Vane mode
Equipped with AutoLearn, Raymarine's
self-learning calibration system

Extended systems

You can connect the SmartPilot controller to other Raymarine SeaTalk equipment
so it can send and receive SeaTalk data:
• it can use waypoint information from a SeaTalk navigation instrument to pro-
vide track control.
• it can use boat speed from a SeaTalk speed instrument to optimize track-keep-
ing performance.
• it can use wind information from a SeaTalk wind instrument for Wind Vane
steering.
You can also use the SmartPilot with any navigator or wind instrument that
transmits National Marine Electronics Association (NMEA) 0183 data.
The SmartPilot control unit can display SeaTalk and NMEA instrument data in a
user-defined selection of data pages.
For further information on other connections to your system see
Commissioning Guide.

1.2 Using the control unit

Switching on and off

All the time that power is applied to the SmartPilot controller, you can use the
disp
• To switch the SmartPilot controller off, ensure it is in the Standby mode, then
hold down the
switch off count down of 4 seconds occurs. Keep the
during this period, to switch off the instrument.
• To switch the instrument back on, hold down the
imately 1 second.
button to switch the instrument off and on as follows:
button for approximately 5 seconds. After this time, a
disp
ST8002 SmartPilot Controller Operating Guide
Non-G systems
(without GyroPlus)
Full basic functionality: uses Raymarine
steering algorithm without AST
Steering to true and apparent wind in
Wind Vane mode
SmartPilot
button pressed
disp
button for approx-
disp