Cutting Warped Material; Clamping Wide Workpieces - Delta HOMECRAFT H26-260L Instruction Manual

CUTTING wARPEd MATERIAL

When attempting to cut warped material, the CONVEX
face should be against the fence as shown in Figure 17.
FIGURE 17

CLAMPING wIdE wORkPIECES

When cutting wide work pieces, such as 2 in. x 6 in.,
clamp the workpiece to the work table using a C-clamp
as shown in Figure 19.
Keep clamps away from the path of
the blade and blade guard assembly.
OPERATION
Never position a piece of warped material with the
CONCAVE face or edge against the fence, as shown in
Figure 18. It will pinch the blade near the completion of
the cut.
the concave edge of bowed or warped material against
the fence.
FIGURE 19
19
To avoid a kickback and to avoid
serious personal injury, never position
X
FIGURE 18
7
6
5
4
3
2
1