Align The Laser Guide; To Remove Your Mark; To Cut On Your Mark; To Cut Without Removing Your Mark - Delta HOMECRAFT H26-260L Instruction Manual

USING ThE LASER GUIdE
When the laser guide switch is turned on it projects a
red line onto the work surface enabling you to see your
cut before you make it. To ensure a true and straight
cut:
1. Make sure the saw is unplugged.
2. Draw a line on the workpiece where you plan to cut.
3. Flip the laser switch (A) to the "ON" position.
4. The red line (B) indicates the path of the blade
5. Align the laser line and the mark with the blade at
the uppermost position.
6. Once both lines are in alignment, do not move the
workpiece.
7. Plug the saw into the power source.
8. Make several practice cuts on different styles and
thickness of material.
9. Repeat the steps above as necessary.

TO REMOvE YOUR MARk:

Position the laser line near the left edge of your mark
on the work surface in order to cut through the mark.

TO CUT ON YOUR MARk:

Position the laser line near or over your mark on the
work surface in order to cut the mark.
TO CUT wIThOUT REMOvING YOUR
MARk:
Position the laser line near the right edge of your mark
on the work surface in order to leave the mark.
After you have become familiar with using the laser
guide, you will be able to remove, cut, or leave your
mark on the work surface. Practice will teach you the
correct position for aligning the laser line with your
mark.
Complies with 21 CFR 1040.10 and 1040.11
Caution: Use of controls or adjustments or
performance of procedures other than those specified
herein may result in hazardous radiation exposure.
FREE wARNING LABEL REPLACEMENT
If your warning labels become illegible or are missing,
user shall remake the label according to copy on
manual and attach on the same location or call 1-800-
223-7278 for a free replacement.
During operation and maintenance , human access
to laser radiation in excess of the accessible emission
limit is possible, so it should avoid direct eye exposure
of laser radiation.
Metal instruments can cause a laser reflector, During
operation and maintenance should avoid direct
PREPARING YOUR SAw FOR USE
exposure in these instruments, as far as possible not
to use reflective instruments! Action should be avoided
with watches, necklaces, bracelets, it can be reflected
laser accessories!
A
15
7
6
5
4
3
2
1
B
FIGURE 15