Equipment Programming; Initial Setup Of New Timers; Menus - Coleman Hanna 93000 Installation & Operation Manual

6. EQUIPMENT PROGRAMMING

There are two buttons located on the back of the timer that are used for setting the price and time, as
well as retrieving information.

6.1 Initial Setup of New Timers

When you first receive your timer and power it up, the display will be flashing zeros. This indicates that
the timer needs to be programmed to function properly. The following menus indicate the information
that will need to be input to make the timer function properly.

6.2 Menus

Let's start by explaining the purpose of each menu.
Menu
A. Number of Coins to Start Vacuum
B. Number of Seconds per Vacuum
C. Number of Minutes Per Vacuum
D. Number of Times Warning Horn
Beeps
H. Amount of Time per Coin After
the Start-Up Price is Satisfied.
Coleman Hanna Carwash Systems
Page 8 of 38
World Class Manufacturing in Car Wash Equipment
SUPER VAC 3 Installation/Operation Manual
Mode
MENUS FOR VACUUM
Valid entries are from 1 to 20 coins to start the vacuum
This menu creates some confusion for customers. TYPICALLY THIS
NUMBER IS LEFT AT ZERO. The menu is in place for those customers who
have a wash that starts at 3:30, for example. In this case, you would enter the
:30 at this point. Valid entries are from :00 to :59.
Valid entries are from 0 to 9.
This is the number of times the user would like the warning horn to sound at
the one-minute mark. Valid entries are from :00 to :59. If the menu is left at
:00, the warning horn is disabled.
This is the amount of time that the customer will receive for each additional
coin deposited after the initial turn-on price is deposited.
Set
Valid Entries
93000/94000 Super Vac
Rev. 2 7/12/10