Brake Fluid Reservoir - Lotus Evora 2011 Owner's Handbook Manual

BRAKE FLUID RESERVOIR

Brake Fluid Reservoir
Under normal circumstances, there is no requirement for
routine 'topping up' of the brake master cylinder reservoir. A
visual safety check is all that is required.
Every week, check the level of fluid in the brake fluid reservoir
located beneath the front body access hatch. Release the hatch
by pushing down the lever at the inboard side of both front foot-
wells (see page 129). The hatch may then be lifted fully open.
Without disturbing the filler cap, check that the level lies
between the 'MAX' and 'MIN' marks moulded on the translu
cent reservoir body. As the brake pads wear, the level will drop
gradually from the 'MAX' mark towards the 'MIN', but if the
level drops rapidly over a short period, have your Lotus dealer
investigate without delay. If the level is found to be below the
'MIN' mark, it is likely there has been some fluid loss, and that air
will have entered the hydraulic system. The car should not be
driven until the fault has been investigated and rectified. Note
that a single reservoir is used to supply both of the independent
hydraulic circuits for the front and rear brakes, and also serves
the hydraulic clutch release circuit.
If any fluid is to be added, first clean the surrounding area
to guard against dirt ingress before unscrewing the reservoir
cap. Take suitable precautions to prevent rain water or other
contamination whilst the cap is removed.
oh_evoraS_a_USA.indd 129
ohe21
129
28/04/2011 11:53:28