Rear Panel - Luxman EQ-500 Owner's Manual

Names and Functions

Rear panel

1
1. Signal ground terminals
(SIGNAL GROUND)
Are ground terminals for devices to be connected to this
unit. These terminals are used to reduce noises when other
devices are connected, and are connected to an analog
player or a tone arm. These terminals are not designed for
safety. There are 3 lines of independent ground terminals
to allow for connecting 3 pieces of analog players or tone
arms.
2. Input terminals (INPUTS)
Are used as an input terminal to connect a pin-plug cable
from an analog player or a tone arm. There are 3 lines of
input terminals to connecte 3 pieces of analog players or
tone arms. The input selection switch can select an input
among 1, 2, and 3.
3. Unbalanced output terminals/
(OUTPUTS) (LINE-1, LINE-2)
RCA terminals to provide unbalanced audio signals of this
unit. Connect these terminals to unbalanced inputs of an in-
put device such as a control amplifier with pin-plug cables.
Audio output signals are selected with the output mode se-
lection switch.
LINE-1 and LINE-2 provide the same sound quality.
When the output mode selection switch is set to BAL, no
audio signal is outputted.
6
2 3 4
4. Balanced output terminals (OUTPUTS)
(BAL. LINE)
XLR output terminals to provide balanced audio signals
from this unit Connect these terminals to balanced inputs
of an input device such as a control amplifier with balanced
cables. Audio output signals are selected with the output
mode selection switch.
When the output mode selection switch is set to UNBAL,
no audio signal is outputted.
5. AC inlet (AC IN)
Connects the accessory power cable.
The power shall be supplied from a household wall socket.
5