Rangemaster 90 User Manual page 36

Disconnect from electricity and gas before servicing. Check ap pli ance is safe when you have finished.
26. To change Main oven light bulb.
Disconnect from the electricity supply.
Remove the oven furniture. Unscrew the bulb.
Fit an Edison screw fi tting 15w 125-130v lamp, FOR
OVENS. It must be a special bulb, heat resistant to 300
°C.
27 To Remove Tall Oven Door
Open oven door, support the door and remove the two
screws securing the upper hinge and packing to the
cooker front. Remove the door from the lower hinge by
lifting slightly and moving outwards.
Reassemble in reverse order.
28. To Change Tall Oven Door Outer Panel
Remove oven door see 16. Lay door face down on a
suitable surface and remove 2 screws from bottom edge
of door and 2 screws from inside face of door.
Remove outer door panel. Remove door handle by
unscrewing 2 screws. Remove 2 cross-headed screws
holding door handle fi xing bracket to door panel. Fit door
handle bracket and door handle to new panel.
Fit panel to door. Reassemble in reverse order.
29. To Change Tall Oven Door Magnetic Latch
Remove the control panel (see 4).
Remove the plinth (3 screws) and the central vertical
cover (5 screws). Prize the retaining clip off the magnet
unit. Fit new unit and retaining clip.
Reassemble in reverse order.
Check correct door operation.
SERVICING - WARNING
36