Table of Contents
Advertisement
(3) Exciter installation
a. (a) Install exciter in accordance with TM-360.
b. (b) Reinstall rear frame member and tighten screws securely.
NOTE: It may be necessary to use a large "C" clamp or other arrangement to position frame side rails and
align rear frame member mounting holes.
d. Engine Control Panel
The engine control panel is designed and mounted in such a manner that it may be released from
its mounted position and tilted outward for access to components mounted on the back side (see
Fig. 8). On dual output units it will be necessary to dismount the No. 2 output control to tilt the
panel forward. Do not disconnect the wires.
(1) Tilt out engine control panel
a. Remove clamp screw which supports wire conduit above output terminal panel.
b. Remove four cap screws which attach engine control panel to frame superstructure.
c. Maneuver panel to tilt it inward at the bottom and outward at the top.
(2) Reinstall engine control panel
a. Maneuver panel into position and align mounting holes. Install mounting screws and secure.
b. Secure wire conduit in its original position with clamp and screw.
May 31/94 Revised
Removable Rear Frame Cross-Member
Figure 7
OM-499
2-1
Page 11
Advertisement
Table of Contents
