Grizzly G0443 Owner's Manual page 20

6. place the intake barrel brace in position
and mark the location of the mounting holes
(shown in figure 14) with a small pencil, nail,
or push pin.
Mounting
hole
locations
figure 14. intake barrel brace positioned to
mark the mounting holes.
7. remove the intake barrel you temporar-
ily attached in Step 4, drill holes where you
marked in Step 5, and loosely install the wall
mount brace to the wall with the remaining
fasteners from the Wall Mounting procedure
on Page 17.
8. use the (12) ⁄ "-18 x
5
16
⁄ " flat washers to re-install the intake barrel
5
16
to the housing with a barrel gasket in between
(see figure 13 on Page 19).
Note: When installing the two bolts above
the intake port, use duct tape on the bottom
of your wrench to hold the bolts in place, as
shown in Figure 15, to start the bolts easier.
figure 15. using tape on wrench in tight spot.
-18-
⁄ " hex bolts and (12)
3
4
9. attach the cyclone funnel to the intake barrel
with a barrel gasket between them, as shown
in figure 16, using (12)
(24) ⁄ " flat washers, and (12)
5
16
nuts; also secure the wall mounting brace to
the lip of the intake barrel/funnel assembly
with the same hardware.
Note: At the places where you see 3 holes in
a row, only use the center hole for this step.
The two outside holes are only designed for
use with the optional stand.
x 12
figure 16. Cyclone funnel attached to intake
barrel.
10. tighten the wall mounting brace to the wall.
11. attach the cyclone vacuum tube to the cyclone
funnel with (4) ⁄ "-18 x
5
16
⁄ " flat washers, as shown in figure 17.
5
16
figure 17. Cyclone vacuum tube and hose
attachment.
Model g0443 (Mfg. since 11/09)
⁄ "-18 x 1" hex bolts,
5
16
⁄ "-18 hex
5
16
Barrel
gasket here
⁄ " hex bolts and (4)
3
4