Carrier Cor TP-WEM01-A Installation Manual page 19

This product was designed and built in accordance to RoHS directive 2002/95/EC
and contains no hazardous substances as defined by this directive.
FCC Compliance Commission (FCC)
Compliance Statement:
This equipment has been tested and found to comply with the limits
for a Class B digital device, pursuant to part 15 of the FCC Rules. These limits are
designed to provide reasonable protection against harmful interference in a
residential installation. This equipment generates, uses and can radiate radio
frequency energy and, if not installed and used in accordance with the
instructions, may cause harmful interference to radio communications. However,
there is no guarantee that interference will not occur in a particular installation. If
this equipment does cause harmful interference to radio or television reception,
which can be determined by turning the equipment off and
encouraged to try to correct the interference by one or more of the following
measures:
Reorient or relocate the receiving antenna.
d
Increase the separation between the equipment and receiver.
d
Connect the equipment into an outlet on a circuit different from that to
d
which the receiver is connected.
Consult the dealer or an experienced radio/TV technician for help. This
d
device complies with part 15 of FCC rules. Operation is subject to the
following two conditions:
1. This device may not cause harmful interference.
2. This device must accept any interference received, including
interference that may cause undesired operation.
Change or modifications that are not expressly approved by the
manufacturer could void the user's authority to operate the equipment.
Approvals
18
on, the user is