c) Prevent unintentional starting. Ensure the GENERAL POWER TOOL SAFETY switch is in the off -position before connecting WARNINGS to power source and/or battery pack, picking up or carrying the tool. WARNING Carrying power tools with your fi nger on the switch Read all safety warnings, instructions, illustrations and or energising power tools that have the switch on specifi...
5) Service Kickback could cause the saw to jump backwards, but a) Have your power tool serviced by a qualifi ed kickback forces can be controlled by the operator, if repair person using only identical replacement proper precautions are taken. parts.
18. Since the saw blade will extend beyond the lower surface ADDITIONAL SAFETY WARNINGS of the lumber, place the lumber on a workbench when cutting. If a square block is utilized as a workbench, 1. Use only blade diameter specifi ed on the machine. select level ground to ensure it is properly stabilized.
SYMBOLS SPECIFICATIONS WARNING The specifi cations of this machine are listed in the Table on The following show symbols used for the machine. page 12. Be sure that you understand their meaning before NOTE use. Due to HITACHI’s continuing program of research and development, the specifi...
Page 11
5. Replacing supply cord If the replacement of the supply cord is necessary, this has to be done by the manufacturer of this agent in order to avoid a safety hazard. 6. Motor unit maintenance The motor winding is an important part of this tool. Avoid damaging and be careful to avoid contact with cleaning oil or water.
Page 12
C7UR (230, 240) V 60 mm 47 mm 1800 W (230 V), 1800 W (240 V) 6800 /min 5.1 kg...