Chevrolet Corvette 2001 Manual page 4

Separator (J-36221), depress White circular release ring on actuator hose while pulling
lightly on master cylinder hose. Remove actuator cylinder hose from hose retaining clip.
Disconnect clutch actuator cylinder hose from clutch master cylinder hose. Protect both
hose coupling ends from dirt and damage.
4. Remove driveline support assembly and transmission from vehicle. See CLUTCH
ASSEMBLY . Remove clutch actuator cylinder mounting bolts and actuator cylinder from
driveline support assembly.
Installation
NOTE: When reconnecting quick-connect hydraulic hose fittings, pull back
on fittings to verify engagement. DO NOT rely on audible click or
visual verification. Also check clutch hydraulic hoses for twists or
kinks.
When installing clutch hydraulic hoses, position hoses away from other components to prevent
damage. To install, reverse removal procedure. Tighten all bolts and nuts to specification. See
TORQUE SPECIFICATIONS . Bleed hydraulic system. See BLEEDING .
CLUTCH ASSEMBLY
CAUTION: When tilting rear of driveline downward, observe clearances
Removal
1. Disconnect negative battery cable. On convertible models, remove folding top storage
compartment lid extension panel. On all models, open console door. Pull up on rear of
traction/ride control switch to release retaining clips. If switch does not release from trim
plate, carefully insert screwdriver into recess at rear of switch and gently pull up on rear of
switch. Disconnect electrical connector from switch, and remove switch.
2. Using small flat-blade screwdriver, carefully remove console retaining nut covers. Remove
front and rear retaining nuts. Remove instrument panel accessory trim plate nuts. Lift rear of
console slightly and pull rearward to release front of console from under instrument panel
trim plate. Disconnect electrical accessory plug connector. Unscrew electrical accessory
plug retainer from housing, and remove housing from console.
3. Disconnect fuel door release switch connector. Remove fuel door release switch. Turn
2001 Chevrolet Corvette
2000-01 CLUTCHES Corvette
between rear of engine and composite dash panel, and
between rear of transmission assembly and underbody. To
prevent vehicle damage, DO NOT allow engine to rest
unsupported against composite dash panel.