Specifications - Chevrolet Corvette 2001 Manual

spin freely, replace bearing.
3. If replacing flywheel, check old flywheel for balance weights inserted in weight holes. If
weights are installed on old flywheel, new balance weights MUST be installed on new
flywheel in same hole locations as on old flywheel. If clutch pressure plate requires
replacement, flywheel MUST be replaced also.
Installation
1. Install flywheel, if removed. Apply Threadlock (12345382) to flywheel bolt threads.
Loosely install bolts. Tighten bolts in sequence in three steps. See Fig. 5 and TORQUE
SPECIFICATIONS . Assemble clutch disc and pressure plate. Adjust clutch pressure plate.
See CLUTCH PRESSURE PLATE (OFF-VEHICLE) under ADJUSTMENTS. Install
clutch assembly to flywheel.
2. Using Clutch Alignment Arbor/Pilot Bushing Installer (J-38836), align clutch assembly to
pilot bearing. Tighten bolts in sequence. See Fig. 5 . Tighten bolts evenly over 3 increments.
See TORQUE SPECIFICATIONS . Install flywheel cover, inspection cover and cover
bolts.
3. Attach driveline to transmission assembly. Use an assistant to install driveline and
transmission in vehicle to keep tilt angle accurate to prevent damage to vehicle. Use only
hand tools to tighten all nuts and bolts to specification. See TORQUE

SPECIFICATIONS .

4. To complete installation, reverse removal procedure. Ensure rear transverse spring stud bolt
has a MINIMUM of 2 threads showing above the nut. Set spring stud height to the height
measured during removal. See Fig. 3 . Adjust vehicle trim height. See appropriate
SPECIFICATIONS & PROCEDURES article in WHEEL ALIGNMENT. Use NEW
crossmember mounting bolts. When reconnecting quick-connect hydraulic hose fittings, pull
back on fittings to verify engagement. DO NOT rely on audible click or visual verification.
Bleed hydraulic system. See BLEEDING .
2001 Chevrolet Corvette
2000-01 CLUTCHES Corvette