Enter the frequency you want to start from by
using the number keys. (Press . /CLR to enter a
decimal point).
Press FUNC and
searches, starting from the frequency you
entered in Step 2.
If you enter a frequency that is out of range, the
scanner sounds an error tone and Error appears.
Press FUNC +
downward or FUNC +
direction upward. Frequencies appear during the
search.
Notes:
•
You can set the delay function on or off during
the search or while the search stops.
•
You can skip a frequency when the search stops.
After the search skip frequency is set, the scan-
ner starts direct search again.
direct entry search hold mode
To stop searching during direct entry search, press
HOLD. HOLD appears. In this mode, pressing FUNC
+
changes the search direction downward and
pressing FUNC +
43
or
. The scanner
to change the search direction
to change the search
changes the search direction
Beyond the Basics