Table of Contents
Advertisement
2.5.1 Set Count Down
To change the Count-Down value, the memory first has to be deleted
To set the Count-Down value:
-
Press the
MEMORY
-
Press the
SPLIT/LAP
-
Press again the
Validate your setting with the
-
2.5.1. Count Down timing
-
To start the count down, press
-
The count-down value decreases (on the bottom line)
-
A timer (on the top) is started (increases)
At any time it is possible to
A long single beep will sound at the end of the Count-Down
The count-down will stop automatically at 00:00
To restart a new count-down, you have to reset the value by pressing the
button
During the count-down sequence, by pressing the
change the Single Count-Down to Auto-Restart Count-down (loop mode)
The
CD
icon on the LCD will switch
In this Auto-Restart Count-Down, during the last 5 seconds, the Pocket Pro will sound
a single short beep and a then long beep at 00:00
The Pocket Pro will restart automatically from the pre-defined time of the count-down
The timer will run and show the full time since the first Start
To stop the sequence, you have to RESET the Pocket Pro
TAGHeuer Timing
button: the first digit will flash and
button to change the value
MEMORY
button to change to the next digit
MODE
START/STOP
PAUSE
and
1.
Number of split / Memory status
2.
Running status
3.
Counter
4.
Count Down (max 59:59.9)
SET
button
(SET
icon is OFF)
button (
RESTART
the count-down
MODE
button, it is possible to
icon is ON
icon is OFF)
SPLIT/LAP
Page 8 / 24
Advertisement
Table of Contents
