For use with Craftsman 315 MHz or 390 MHz garage door openers manufactured after
January 1, 1993. The garage door opener activates when the programmed button on the
remote control is pressed. The remote control can activate up to three garage door openers.
Make sure the garage door opener has a working light bulb because it is a programming
PROGRAM THE REMOTE CONTROL (139.18802)
Press and hold the program button
the remote control until the LED on
the front of the remote control
Press and release the Learn
button on the garage door
The Learn LED will light.
Within 30 seconds...
Press and release the remote control button you wish to use the
number of times that corresponds with the garage door opener type:
# of Presses
Press the remote control button
programmed in step 2 until the
garage door opener lights ﬂash
or two clicks are heard.
MODELS 139.18802 AND 139.18803
Locate the Learn
button on the garage
NOTE: Your garage door
opener may look different.
Garage Door Opener Type
(Yellow Learn Button)
315 MHz Security+
(Purple Learn Button)
390 MHz Security+
(Red/Orange Learn Button)
390 MHz Billion Code (Green Learn Button)
To test, press the programmed
button on the remote control...
3-BUTTON REMOTE CONTROLS
To prevent possible SERIOUS INJURY or
DEATH from a moving gate or garage door:
• ALWAYS keep remote controls out of
reach of children. NEVER permit children
to operate or play with remote controls.
• Activate gate or door ONLY when it can be
seen clearly, is properly adjusted and there
are no obstructions to door travel.
• ALWAYS keep gate or garage door in sight
until completely closed. NEVER permit
anyone to cross path of moving gate or
Locate the Program button on the
To exit programming mode,
press any remote control
button except the button
that was just programmed.
Install the visor clip.
The garage door
opener will activate.