J TO comply
wire FOG ru_es, ad]u_
o( mod_ftcalJoe, s of _[.s reo_0r
tt_o code _,etttn_ or repla_r_
THERE ARE NO OTHER
remote control (with blue push buttons)
works only with rolling i:ode door openers and light
(with an orange SRT button and yellow
Indicator light). The code between the remote control
and the receiver changes wtth each use, randomly
accessing over 100 billion new codes.
are given below for programming
opener to match the remote control's code. The
remote control buttons can also activate
garage door openers and/or light
are Included with those accessories.)
the Opener to Accept
the Remote Control
Select a remote control push button to operate the
receiver° The large button is recommended
for use with
the garage door opener.
ff you have a Premium
1: W?th the door closed, press and hold the selected
remote push button. See Figure 1.
2. Press and hold the Light button on the door control,
3. Press and hold the door control push button.
4. After the opener light flashes, release all buttons.
ff you do not have a Premium
1. Press and hold the selected remote push button. See
2. Press and release the.SRT (learn) button on the opener
panel. See Figure 3oThe indicator light on the panel wili
begin to blink and the opener light wili flash once,
3 Release the remote p_sh butt6n.
Now the opener will operate when that remote control
button is pressed,r Test it by pressing the remote button to
see that the door goes up and down,,
To Erase All Remote Control
Press and hold the SRT button on the opener panel until
the indicator light turns off (about 6 seconds). All remote
codes are now erased, Then follow the steps above to re-
program each remote control.
or playing with
door could close and cause serious Injury
or death. Do not allow childr.en to operate
or remote control(s).
garage door could
injure or kill someone
when you can
see the door clearly,
It is free of obstructions,
Select a remote cont.,-o_ push button
_ Remote Control
Garage Door Opener
on the opener panel.
the Opener Ligtlt (Premium Consoles)
remote controEs, a push button can be
programmed to operate the opener light without opening
1_ With the door closed, press and hold the remote button
that you want to control the light
2. Press and hold the Light button on the door control.
3 Press and hold the Lock button on the door control.
4. After the opener light flashes, release aHbuttons,
Test by pressing the remote push button, The opener light
should turn on or off but the door shouid not move.