Craftsman 139.18802 Manual page 2

PROGRAM THE REMOTE CONTROL (139.18803)
1
Press and hold the program button
the remote control until the LED on
the front of the remote control
turns on.
Safety pin or
paper clip
4
Press and release the Learn
button on the garage door
opener.
Learn
Button
The Learn LED will light.
Within 30 seconds...
BATTERY
The LED on your remote will stop flashing when the battery is low and needs to be replaced.
To replace battery, open the case as shown. Insert battery positive side up (+). Replace the battery
with only 3V CR2032 coin cell batteries. Dispose of old battery properly.
139.18802
Pry open the case first in the middle (1), then
at each side (2 and 3) with the visor clip.
2
1
3
REPLACEMENT PARTS
Battery . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 10A20
Visor Clip
(Model 139.18802 ONLY) . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 29B137
2
Press and release the remote control button you wish to use the
number of times that corresponds with the garage door opener type:
# of Presses
1
2
3
4
5
Press the remote control button
programmed in step 2 until the
garage door opener lights flash
or two clicks are heard.
Pry open the case with a screwdriver blade.
Garage Door Opener Type
Security+ 2.0 TM (Yellow Learn Button)
315 MHz Security+ ® (Purple Learn Button)
®
390 MHz Security+ (Red/Orange Learn Button)
390 MHz Billion Code (Green Learn Button)
6
To test, press the programmed button on the remote control...
139.18803
3
To exit programming mode,
press any remote control
button except the button
that was just programmed.
To prevent possible SERIOUS INJURY or
DEATH:
• NEVER allow small children near batteries.
• If battery is swallowed, immediately notify
doctor.
To reduce risk of fire, explosion or chemical
burn:
• Replace ONLY with 3V CR2032 coin
batteries.
• DO NOT recharge, disassemble, heat
above 212° F (100° C) or incinerate.
NOTICE: To comply with FCC and or Industry Canada rules (IC),
adjustment or modifications of this receiver and/or transmitter
are prohibited, except for changing the code setting or replacing
the battery. THERE ARE NO OTHER USER SERVICEABLE
PARTS.
Tested to Comply with FCC Standards for Home or office use.
Operation is subject to the following two conditions: (1) this
device may not cause harmful interference, and (2) this device
must accept any interference received, including interference
that may cause undesired operation.
To order replacement parts call...
1-800-4-MY-HOME ® (1-800-469-4663)
The garage door
opener will activate.