Download  Print this page

Update Firmware; Download The Update File; Update From The Configuration Page - Philips AD6000W/10 User Manual

Hide thumbs

Advertisement

6 Update
firmware
Note
You can only update the firmware from a PC/Mac.
Download the update file
www.philips.com/support
1
On your PC/Mac, go to www.philips.com/
support.
2
Enter the model number to find the latest
firmware upgrade file available.
3
Save the upgrade file to your hard drive.
EN
20
XXXX
XXXX. zip
Update from the
configuration page
Warning
Always connect your AD6000W to AC power for
firmware upgrade. Never power off your AD6000W
during firmware upgrade.
Note
To use an Internet browser other than Apple Safari
on your PC/Mac, remember to go to the Wi-Fi router
configuration page and write down the IP address of
your AD6000W. See the user manual of your Wi-Fi
router for how to find the IP addresses of devices
connected to the Wi-Fi router.
1
Power on AD6000W (see 'Turn
AD6000W on' on page 9).
» It takes about 35 seconds for the unit
to boot up. During boot-up, the WI-FI
SETUP indicator on the back of the
unit blinks green quickly.
» After boot-up, you can hear a beep
and the WI-FI SETUP indicator
turns to green steadily. AD6000W is
connected to the last configured Wi-Fi
network automatically.
2
Make sure that AD6000W and your PC/
Mac are connected to the same Wi-Fi
router.
3
Open Apple Safari on your PC/Mac, then
select 'Philips_Fidelio XXX' from the
Bonjour pull-down list.
Or open any other Internet browser
on your PC/Mac, then type in the IP
address of AD6000W (available on
the Wi-Fi router configuration page)
at the address bar.
» The AD6000W configuration
web page is displayed.

Advertisement

loading

  Related Manuals for Philips AD6000W/10