Booting The Cisco Catalyst 3850 Switch In Bundle Mode; Updating Cisco Ios Xe Software - Cisco Catalyst 3850 Deployment Manual

Hide thumbs Also See for Catalyst 3850:
Table of Contents

Advertisement

Note:
supported.

Booting the Cisco Catalyst 3850 Switch in Bundle Mode

Booting a Cisco Catalyst 3850 Switch in bundle mode is just like booting a monolithic Cisco IOS Software image on
a Cisco Catalyst 3750-X Switch.
This command boots the switch in bundle mode:
switch: boot flash:cat3k_caa-universalk9.SPA.03.07.00.E.152-3.E.bin
Reading full image into
memory...........................................................................
.................................................................................
.................................................................................
..............................................................done
Bundle Image
<Output Truncated>
Note:
packages are extracted from the bundle and copied to the RAM.
You can boot the switch in bundle mode from the built-in flash memory, an external USB drive (usbflash0), or
TFTP. Bundle mode is used to boot a Cisco Catalyst 3850 Switch from the boot loader prompt.

Updating Cisco IOS XE Software

When the switch is in install mode, you can install any new Cisco IOS XE Software bundle by using the software
install command.
Note:
Use the show switch command to check the status of the switch or switch stack. This example shows the status
of a two-switch stack, where switch 1 is active:
Switch# show switch
Switch/Stack Mac Address : 00e1.6d52.c600 - Local Mac Address
Mac persistency wait time: Indefinite
Switch#
-------------------------------------------------------------
*1
2
© 2015 Cisco and/or its affiliates. All rights reserved. This document is Cisco Public Information.
Booting in install mode from a USB flash drive or using Trivial File Transfer Protocol (TFTP) is not
Booting the switch in bundle mode consumes more memory than booting in install mode because the
This command works only when the Cisco Catalyst 3850 Switch is booted in install mode.
Role
Mac Address
Active
00e1.6d52.c600
Standby
44ad.d96d.b480
H/W
Current
Priority
Version
State
15
V03
Ready
1
V01
Ready
Page 7 of 36

Advertisement

Table of Contents
loading

Table of Contents