Data Label - Electrolux T5290 Installation Manual

Installation manual
27
• Loosen the measuring branch screw (2) 1/4 turn; connect a manometer to the measuring branch.
• Connect the power to the machine and select a program with heat.
• Start the machine.
• Set the correct nozzle pressure according to the table on setting screw (4) under the cover screw (3).
fig.7120
• Check that the gas flame burns evenly.
• Mount the cover screw (3).
• Remount the lower back panel.

8.7 Data label

When the machine is to be converted to another gas type, the data label at the rear of the machine must be updated
in order for the data to be correct.
Place the data label enclosed in the conversion kit on top of the data label as shown below. If there are more than
one data label, select the label with the correct country code and gas type.
fig.7110