Connecting Inputs; Low-Level Inputs - Radio Shack XL-260 Owner's Manual

12-2017.fm Page 8 Tuesday, May 9, 2000 10:02 AM
6. Use a screwdriver to connect the spade
end of the supplied red power cable
(with in-line fuse holder) to the ampli-
fier's + 12V terminal.
7. Connect the other end of the red power
cable to your vehicle's positive (+) bat-
tery terminal as shown. Then tighten the
terminal.
ˆ

Connecting Inputs

LOW-LEVEL INPUTS

You can connect your auto sound system's
low-level line out jacks to the amplifier's low-
level line in jacks.
If your auto sound system does not have
low-level line out jacks, see "High-Level
(Speaker Wire) Inputs" on Page 9 to connect
your amplifier.
8
Caution: Due to the amplifier's high cur-
rent requirement, you must connect the
red power cable's fused end directly to
the vehicle's positive (+) battery terminal
or damage to your vehicle's wiring could
result.
Do not reconnect your vehicle's negative (–)
battery cable yet.
Note: For the best results, use shielded au-
dio cables (not supplied) available at your lo-
cal RadioShack store.
1. Temporarily place the amplifier as close
as possible to the selected mounting
location.
2. If your auto sound system has four sep-
arate line out jacks , connect the auto
sound system to the amplifier.
Right Rear
Auto Sound System
Left Rear
Connecting Inputs
Right Front
Left Front