10-0299 Olct 200 Battery I/O Pcb With Power Switch; Wireless Communication Setup - Oldham OLCT 200 User Manual

Holding the magnet to the UP key for >8 seconds forces a transmission of the current
reading value.

6.4 #10-0299 OLCT 200 Battery I/O PCB with Power Switch

Battery powered wireless OLCT 200 electronics consists of the lower 10-0299/Battery
I/O PCB (Figure 2-3) connected by a cable to the upper Display assembly with 10-0291
RF Module PCB (Figure 2-3). The 10-0293 3.6 volt lithium 'D' cell battery will
continuously power the unit for up to one year and may be replaced by following the
procedure in Figure 6-1.
Power switch (SW1), on the 10-0299 Battery PCB, applies battery power to the OLCT
200 monitor. SW1 should be OFF if the monitor is to be out of service for long periods.
IMPORTANT: Do not turn SW1 ON until the controller designated as Server is fully
operational and ready to communicate to the OLCT 200. Battery life is reduced if the
OLCT 200 is on for long periods while unable to communicate to the Server controller.
IMPORTANT: DO NOT ATTEMPT TO CHARGE THIS BATTERY OR REPLACE
WITH ANY OTHER THAN PART # 10-0293 FROM OLDHAM.
Figure 6-1: 10-0299/Battery I/O PCB

6.5 WIRELESS COMMUNICATION SETUP

The Communications menu provides access to RADIO SETUP menus described
below. Hop Channel and System ID settings must match these settings in the Server.
Remote ID must be unique to each OLCT 200. Items tagged with an asterisk affect
power consumption and may have significant affects upon battery life.
OLCT 200 User Manual | 57