Measuring Resistance - NexxTech 2211813 Operator's Manual

3. Connect test leads in series with the load in which the current is to be measured.
4. Read LCD display. The polarity of red lead connection will be indicated when making a DC
measurement.

3.3 MEASURING RESISTANCE

1. Connect the black test lead to the COM jack and the red test lead to the V/Ω jack. (NOTE: The
polarity of the red lead connection is positive "+")
2. Set the function switch at Ω range to be used and connect test leads across the resistance under
measurement.
NOTE:
1. For resistance above 1MΩ, the meter may take a few seconds to stabilize reading. This is
normal for high resistance measuring.
2. When the input is not connected, i.e. at open circuit, the figure "OL" will be displayed for the over
range condition.
-12-