Connecting The Antenna; Using Vehicle Battery Power - Radio Shack PRO-95 Owner's Manual

1. Connect the Adaptaplug to
CAUTION
You
!
must
use a
2. Plug the adapter's barrel plug
Class 2 power
source that
supplies 9V DC
and delivers at
3. Plug the adapter's two-prong
least 300 mA. Its
center tip must be
set to positive and
Using Vehicle Battery
its plug must fit
Power
the scanner's
You can power the scanner from a
PWR DC 9V jack.
vehicle's 12V power source (such
Using an adapter
as cigarette-lighter socket) using a
that does not
9V, 300 mA DC adapter and a size
meet these
B Adaptaplug™ adapter (neither
specifications
supplied). Both are available at
could damage the
your local RadioShack store.
scanner or the
adapter.
1. Connect the Adaptaplug to
• Always connect
the AC or DC
adapter to the
scanner before
2. Plug the adapter's barrel plug
you connect it to
AC power or
power source.
When you finish,
3. Plug the adapter's cigarette-
disconnect the
adapter from AC
power or the
power source
C
before you
A
disconnect it from
the scanner.
To attach the supplied flexible
antenna to the antenna jack on the
Ô Ô
NOTE
top of your scanner, align the slots
If the scanner does
around the antenna's connector
not operate properly
with the tabs on the antenna jack.
when you connect a
Press the antenna down over the
DC adapter, unplug
jack and turn the antenna's base
the DC adapter from
clockwise until it locks into place.
the power source and
clean the socket, or
check the adapter's
internal fuse.
12
the adapter's cord with the tip
set to positive.
into the scanner's
PWR DC 9V
jack.
plug into an AC outlet.
the adapter's cord with the tip
set to positive.
into the scanner's
PWR DC 9V
jack.
lighter plug into your 12V
Ô
power source.
ONNECTING THE
NTENNA