Empire Comfort Systems DF28GBL-1 Installation Instructions

FOR USE WITH VENT FREE FIREPLACE INSERTS
INSTRUCTIONS MUST BE LEFT WITH THE OWNER FOR FUTURE REFERENCE AFTER INSTALLATION
Assembling the Glass Front
1. Place glass front on a soft surface, such as carpet, with screen
print facing up (smooth, glass side down).
2. Lift each corner up and place the cap and rubber washer into
the hole in the glass. See Figure 1.
SCREW #10-24x3/8" LONG
(4 REQ'D)
GLASS BRACKET
LEFT
GASKET
(2 REQ'D)
RUBBER WASHER
(4 REQ'D)
3. Lay gasket material on the glass aligning the holes with the
holes in the glass.
4. Place the right and left glass brackets on the glass with the
mounting flanges to the outside. Attach the #10-24 screw to
the cap. Repeat on the bottom hole. Repeat on the opposite
side. See Figure 1.
5. Tighten the screw into the cap. Caution: Do not over tight-
en.
6. Attach the two (2) glass front top brackets to the top of
the glass brackets with six (6) #8-15 screws as shown in
Figure 2.
GLASS FRONT
TOP BRACKET (2 REQ'D)
SCREWS (4 REQ'D)
28049-0-0311
CONTEMPORARY GLASS FRONT SURROUND

INSTALLATION INSTRUCTIONS

MODELS: DF20GBL-2, DF28GBL-1
GLASS BRACKET
RIGHT
GLASS FRONT
(PAINT SIDE UP)
CAP (4 REQ'D)
Figure 1
Figure 2
Assembling the Trim to the Fireplace
1. Once the fireplace is installed, use the included trim to cover
the screw heads. Attach the trim to the fireplace using two (2)
#8-15 screws. Repeat on the opposite side.
Caution: Do not to over tighten the screws. See Figure 3.
2. To install the top trim, loosen the two (2) hex head screws
with a wrench. The screws are located on the top of the outer
wrapper. Slide the top trim in place and tighten the screws.
See Figure 4.
Figure 3
Figure 4
Page 1