How Do I Reset My Scanner - Radio Shack PRO-528 User Manual

Type II systems. Set the scanner to receive
Type I trunked frequencies. See "scanning
type I and hybrid trunked systems".
The selected fl eet map is incorrect. Try
another preset fl eet map or program your
own fl eet map (see "scanning type I and
hybrid trunked systems").
Enter all of the trunk's frequencies: see
"programming trunked frequencies".

How do I reset my scanner?

If the scanner's display locks up or stops
operating properly, you might need to reset
the scanner.
Caution: This procedure clears all the
information you have stored in the scanner.
Before you reset the scanner, try turning
it off and on to see if it begins working
properly. Reset the scanner only when you
are sure it is not working properly.
1. Turn off the scanner.
2. While holding down 2, 9 and HOLD/
RESUME, turn on the scanner. CLEAr
fl ashes for about 5 seconds as the
scanner clears its memory.
Note: Do not turn off the scanner
again until CLEAr stops fl ashing.
Notes
Otherwise, the scanner might not
clear its memory properly.
Beyond the Basics
83