Tablet Controller - Midtronics DSS-7000 Instruction Manual

Chapter 1: Introduction


Charger Port: Plug in point for the Diagnostic Device charger.

USB port

RJ45 Connector: For accessory cable connection.

Temperature Sensor: For measuring the ambient tem-
perature of a battery during the testing procedure.

Control Panel

Power Button: For powering up analyzer when not con-
nected to a battery.

Tablet Controller Release Button: Press to release the
Tablet Controller module from the Diagnostic Device.


Status LEDs

Power: Green when analyzer is on.

Charging: Red
- analyzer charging or needs charging, or
Green - fully charged.

Check Connection: Red
Green - clamp connection OK.

Communication: Flashes
vice is communicating with the Tablet Controller.

Reverse Connection:
clamps OK.
Midtronics Inc. 7000 Monroe Street


Top View




- check clamp connection, or
Blue
when the Diagnostic De-
Red
- clamps reversed, or
Willowbrook, IL 60527

Tablet Controller


Touch Screen: Primary user interface.

Camera: For VIN scanning and identification

Diagnostic Device Connection: For when the Tablet
Controller is docked with the Diagnostic Device.

Charger Port: Plug in point for the Diagnotic Device charger.

Power Button: For turning the Tablet Controller on and
off independent of the Diagnostic Device.
Green
-
6

Front View

Rear View


Side View
DSS-7000

www.midtronics.com