Table of Contents
Advertisement
BlueNAC-3000
– User Guide English
9
®
• Redial the last number: press and hold "Phone key" for about 3 seconds to re-dial the last number (you will
hear a synthesized voice confirmation, that says "RECALL")
End a call
There are several ways to end a call:
• Wait for the other person hang up.
• Briefly press once the ON/OFF key (you hear a confirmation tone)
• Press the "END key" on your mobile phone (You shouldn't do this action in a moving vehicle)
USE OF BLUETOOTH GPS NAVIGATOR
To use the functions of a GPS, make sure both units are stwich-on and synchronized properly, following the
process described in the "PAIRING/SYNC" section.
[!] Attention:
Communicating with a GPS has high priority, which means that, while you hear the GPS
instructions, intercommunication is temporarily disabled. Once the GPS communication end, the intercom is
automatically restored.
Play voice commands on your Navigator
These traffic instructions are transmitted cutting temporarily the intercommunication. Once transmited these
instructions, BlueNAC-3000 automatically restart the intercom mode.
Listen music from your Navigator
Most modern Navigators allow listen music while not transmit any information. In this case, communication
with the Navigator is continuous thus preventing intercommunication.
Using a mobile phone with a Navigator
If you have synchronized your Navigator with a BlueNAC-3000, you cannot connect directly your mobile
phone to BlueNAC-3000, but instead this, you can connect the phone using the Navigator. By doing that, all
the phone functions are controlled from the Navigator. For more information on how to synchronize the mobile
phone with a Navigator, read the Navigator user manual.
UPDATE BY USB PORT
You can access to our web
http://www.bluenac3000.es
to download the free updates, software and firmware.
For connect the BlueNAC-3000 to a PC to update it, is required a standard mini-USB cable, a free USB input
on your computer and internet access.
The instructions to update it are on this website. Once installed the software and drivers on your PC, you can
access to the control panel that lets you make adjustments in BlueNAC-3000 graphically and simple, or you
can check for a new firmware update with possible improvements or changes.
Advertisement
Table of Contents
