Description Of The 4 Levels Of Settings In Setup Mode; Indications Of The Leds; Instalation And Fixing System (See Annex I); Fixing To The Helmet - NAC Intercom BlueNAC-3000 User Manual

BlueNAC-3000

Description of the 4 levels of settings in SETUP mode

1. Monitoring or SIDETONE: This is the first parameter can be adjusted when you enter in SETUP
mode. Once you hear the word "SIDETONE" you can change the volume level with which you hear
our own voice respect the overall volume.
2. Sounds Volume: You hear the word "SOUNDS" which allows us to vary the volume of the sound
signals and synthetic voices that are heard when pressing the keys.
3. VOX: You hear the word "VOX" to adjust the trigger level for the microphone depending on the
proximity of the mouth and the noise sources. If you go up that level, it will be harder to activate the
communication and you should speak louder. If you go down it will be easily activated.
The VOX allows to keeps the amplifier and the transmission activated while talking. After 5 seconds in
silence or with a noise level below the programmed threshold it will turn off both, the amplifier and the
transmission automatically.
4. Exchange configuration PILOTO ◄ ► COPILOTO. We heard a synthetic voice that tells us which
device it is, "PILOT" or "COPILOT" and pressing▲ or ▼ role changes and restart the device.
In order to activate the intercom should be a Pilot and Copilot. Before pairing two devices with
BlueNAC-3000, you must ensure that one is a Pilot another one a Copilot. Usually this action is not
necessary if two devices BlueNAC-3000 purchases together.

Indications of the LEDs

During power up the LEDs display device configuration:
Blue Led
Red Led
After 4 seconds after power on, the device status display:
Blue Led
Red Led
Both Led's

INSTALATION AND FIXING SYSTEM (SEE ANNEX I)

The intercom system BlueNAC-3000 consists of: an intercom device, a set of micro-headphones
with two types of microphones and a USB charger.
It is designed to be installed on the left side of a helmet, chin strap or flip open, using for fixing a
system called Dual Lock ™, with VHB adhesive, from 3M.
The micro-headset has a connector specifically designed to waterproof the junction with the
intercom and two types of microphones: A flexible arm for open helmet or chin flip-side, and other to
use in integral helmets.

Fixing to the Helmet

This is done by an adhesive system in the left area, in a position that is comfortable for further management
with the fingers. Make sure the area is clear of dirt or moisture. The system used is the closure adhesive Dual
Lock ™, with VHB adhesive, of 3M: A lightweight solution, clean and safe. The result is excellent clamping
force to replace the conventional closure methods (mechanical) in many applications. The long duration of
closures 3M Dual Lock ™ allows for hundreds of open-close operations. The system works like an advanced
Velcro, we must press closure strips until you hear a click that tells us that it is properly attached. Once set,
the adhesive bond will reach its maximum at 24 or 48 hours.
– User Guide English
®
Flashing during 4 seconds
Flashing during 4 seconds
Fixed
Flash every second
Flash twice every second
Blinking
Fixed
Flashing simultaneously
Flashing alternately
Pilot mode device initializing
Copilot mode device initializing
Not connect any device
Linked to device
Audio channel established (intercom)
Low battery charge
Dead battery or charging
SETUP Mode
Pairing/Sync Mode
5