Table of Contents
Advertisement
BlueNAC-3000
The volume keys in BlueNAC-3000 control, by default, the listening volume of active communication
(intercommunication with other BlueNAC-3000, phone call in progress, etc.). In addition, you can also adjust
other settings in the menu mode volume as the volume of monitoring or tones. (See Settings in SETUP mode)
USE OF TWO BLUENAC-3000 DEVICES
To use the intercom mode, make sure both units are switching-on and pairing. The Intercom function is
disabled when there is an incoming call or when you have connected a GPS navigator which gives some
instruction. The intercom mode was re-activated as soon as the call or instruction ends.
[!] Attention:
Some mobile phones cut off calls after a few seconds, which means that the Intercom function
may not be available immediately.
The Intercom function is activated by voice (VOX). To start a conversation with the intercom, simply start
talking. The communication is active for as long as you are talking. If no conversation, the function is
deactivated after 5 seconds. To reactive, simply speak.
After 30 seconds of inactivity, the intercom passes to sleep mode to save power, you hear a beep
characteristic, blue led blink once per second instead two flashes every second.
[!] Attention:
When using the intercom function after a period of inactivity, the first time you activate the
communication will start with a small delay because the devices are in sleep function to save power and must
be reactivated. You will know that its happens because in the sleep state blue LED blink once every second
and when reactive the audio connection you hear a faint beep characteristic and the blue LED will flash twice
every second.
For this reason, it is possible that the first word is cut or you don't heard it, so it is recommended to start a
conversation with a blow or an "OOH", "YES", "HELLO" or a short expression to allow intercom function was
activated. After this, communication will start automatically.
Two BlueNAC-3000 units can communicate to a distance up 50 meters. Therefore, they are appropriate for
communication Pilot-Copilot, although you can use them to communication at distance not exceeding 30
meters. The maximun range depends on the environment where they are used.
USING THE MOBILE PHONE FUNCTION
To use a mobile phone, make sure that the two units are switch-on and synchronized properly following the
process described in the PAIRING/SYNC section.
[!] Attention:
Calls are always private and have high priority, which means that the intercom function is
temporally disabled while there is an incoming call and is restored when the call ends or if you decide to reject
it.
Answering a call
When you hear the dial tone, press the "phone key"
Rejecting a call
If you don't want to responding, you can let the phone ring or press the ON/OFF
a confirmation tone).
Make a call
There are several ways to make a call.
• From the keypad from your mobile phone: Making a normal call from your phone (You shouldn't do this
action in a moving vehicle)
• For voice command briefly press the "Phone key
the synthesized voice "SPEAK NOW" and then a signal to indicate when you should say the contact's name
you want to call. The correct operation of this function depends on the type of helmet used (open-face or
integral) and the speed at which it is moving. We suggest you perform a few tests to determine the best
settings.
– User Guide English
®
or HF "Hands Free key" and begin speaking.
". If your phone supports voice call system, briefly hear
8
at once (you will hear
Advertisement
Table of Contents
