Fixing Earphones; Fixing Microphone; Match Bluenac-3000 Each Other - NAC Intercom BlueNAC-3000 User Manual

BlueNAC-3000

Fixing Earphones

Velcro can be easily pasted into the speakers inside the helmet. In the helmets where the inner liner
is foam, perhaps no need to use the adhesive, since the Velcro is usually set directly. Be sure to
adjust the height position of the ear at the same height on each side. If pasted at different heights or
offset, this will cause the sound to appreciate unbalanced or lower than usual.
In one of the speakers, the cable is longer to ensure it reaches the far side of BlueNAC-3000. This
should be the right ear (because we will fix the BlueNAC-3000 on the left side of the helmet). The
cable must be passed by the rear of the helmet, between the cork and the casing, avoiding damage
to the cable. In some helmets a flap on the back can easily disguise the cable.

Fixing Microphone

The BlueNAC-3000 incorporates two different mounting systems microphone, depending on
whether the helmet is complete, open, or chin flip (modular).
• In the case of open helmet, mic incorporates a flexible tube that attaches to the outer helmet with
a Velcro on the opposite side BlueNAC-3000 (right), or can be placed between the internal
padding and the housing of the helmet to make it fully integrated. Be sure to measure the
distance to the mouth before setting the microphone to the helmet. The cable will pass the same
way that the right speaker for the rear of the helmet, between the cork and the housing.
• In the case of integral helmet you should use the microphone without tube, fixed inside of the
chin right in front of the mouth. It is advisable to check the exact point of attachment prior to
installation and with the helmet on. You must then insert the cable between the foam from the
BlueNAC-3000 to the microphone, trying to stay hidden. In case you cannot insert the wire
between the cork and the housing for design reasons of the helmet, small strips adhesive for
attaching the cable inside the helmet are included.
[!] Attention: Remember set the BlueNAC-3000 to the left side of the helmet, which is the natural
way for handling with the opposite hand on the throttle of the bike. Take references of suitable areas
to set all the components before starting the installation.

MATCH BlueNAC-3000 EACH OTHER

This action will only necessary if you want to match two BlueNAC-3000 devices that were not purchased
together or if we want to combine them with a module BlueNAC3000 Radio-Link.
To perform this action correctly, we must first make sure that both devices correspond to a Pilot and Copilot
respectively.
This is very easy to know, because when you turn on any of them, you'll hear a synthesized voice tells us
"PILOT" or "COPILOT" according to the previous settings. Or either visually while switch-on during 4 seconds,
the blue LED blinks in Pilot device, whereas red LED blinks if that is Copilot.
Once we verified that, we must turn off both devices and proceed as follows:
•
Turn on each device again holding down ON/OFF key at least 8 seconds, instead of 3 seconds, until
the LEDs start blink alternately.
•
If you are pairing 2 Headsets or 2 Intercom-motorbike, you must wait at least 2 minutes until it
finishes. If it is completed successfully, both devices will restart and the blue LED will blink every
second.
•
If you are pairing Headsets or Intercom-motorbike with a BlueNAC3000 Radio-Link, this procedure
should be applied to the 3 devices and probably will finish faster. Eventually all devices will restart and
the blue LED will blink every second.
•
In the case this procedure does not successfully completed, repeat full procedure again.
– User Guide English
®
6