Loading A Scenario To The Device; Exiting Scenario Mode; Deleting A Scenario - AudioCodes Mediant 3000 User Manual

5.6.6.4

Loading a Scenario to the Device

Instead of creating a Scenario, you can load a Scenario file (data file) from your PC to the
device.

To load a Scenario to the device:
1. On the Navigation bar, click the Scenarios tab; the Scenario appears in the Navigation
tree.
2. Click the Get/Send Scenario File button (located at the bottom of the Navigation tree);
the 'Scenario File' page appears (refer to 'Saving a Scenario to a PC' on page 61).
3. Click the Browse button, and then navigate to the Scenario file stored on your PC.
4. Click the Send File button.
Notes:
•
The loaded Scenario replaces any existing Scenario.
•
Instead of using the Web Interface, you can load an ini file to the device with the
ScenarioFileName ini file parameter.
5.6.6.5

Exiting Scenario Mode

When you want to close the Scenario mode after using it for device configuration, follow
the procedure below:

To close the Scenario mode:
1. Simply click any tab (besides the Scenarios tab) on the Navigation bar, or click the
Cancel Scenarios button located at the bottom of the Navigation tree; a message box
appears, requesting you to confirm exiting Scenario mode, as shown below.
Figure 22: Confirmation Message for Exiting Scenario Mode
2. Click OK to exit.
5.6.6.6

Deleting a Scenario

You can delete the Scenario by using the Delete Scenario File button, as described in the
procedure below:

To delete the Scenario:
1. On the Navigation bar, click the Scenarios tab; a message box appears, requesting
you to confirm:
2. Click OK; the Scenario mode appears in the Navigation tree.
User's Manual
Figure 23: Scenario Loading Message Box
62
Mediant 3000 with TP-6310 & TP-8410
Document #: LTRT-95211