Setup; Unfolding The Handle; Figure - Toro 20355 Operator's Manual

Setup

Important:
Remove and discard the protective plastic sheet that covers the engine and any other
plastic or wrapping on the machine.
1

Unfolding the Handle

No Parts Required
Procedure
WARNING
Unfolding the handle improperly can damage the cables, causing an unsafe operating
condition.
• Do not damage the cable(s) when folding or unfolding the handle.
• Ensure that the cable(s) are routed to the outside of the handle.
• If a cable is damaged, contact an Authorized Service Dealer.
1. Unlock the handle (A of
2. Move the handle rearward to the operating position (B of
3. Set the handle lock until the pin clicks in place to lock the handle into the operating position (C of
Note:
To adjust the handle height, refer to

Figure

3).
Figure 3
Adjusting the Handle Height (page
Figure 3).
5
10).
Figure 3).
g232815