Adjusting The Self-Propel Drive - Toro 20355 Operator's Manual

Adjusting the Self-Propel
Drive
Whenever you install a new self-propel cable or if
the self-propel drive is out of adjustment, adjust the
self-propel drive.
1. Turn the adjustment knob counterclockwise to
loosen the cable adjustment
Figure 30
1. Self-propel-drive cables
2. Handle (left side)
3. Adjustment knob
2. Adjust the tension on the cables
pulling them back or pushing them forward and
holding them in that position.
Note:
Push the cables toward the engine to
increase the traction; pull the cables away from
the engine to decrease the traction.
3. Turn the adjustment knob clockwise to tighten
the adjustment of the cables.
Note:
Both of the cables should extend 38 mm
(1.5 inches) past the clamps when the handle is
aligned with the first mark on the guide; refer
to Figure 31.
(Figure 30).
g208188
4. Turn the knob clockwise to
tighten the adjustment.
5. Turn the knob
counterclockwise to
loosen the adjustment.
(Figure 30) by
1. 38 mm (1.5 inches)
2. Guide
22
Figure 31
3. First mark
4. Handle
g209518