Toro 20355 Operator's Manual page 18

Figure 21
2. Ensure that the cutting-height setting on the
machine is 35 mm (1-3/8 inches) or higher; if
it is not, lower it; refer to
Height (page 11).
3. Disengage the handle locks
Figure 22
1. Handle lock engaged
position
4. Fold the handle fully forward
Important:
Route the cables to the outside
of the handle knobs as you fold the handle.
5. Engage the handle locks.
6. Lift the front of the machine by the handle and
move it into a storage space
decal133-8198
Adjusting the Cutting
(Figure 22).
g189218
2. Handle lock disengaged
positions
(Figure 22).
(Figure 23).
18
Figure 23
g189217