Adjustment Instruction - LG 60PH6700 Service Manual

1. Application Range
This spec. sheet applies to PA32A chassis applied PDP TV all
models manufactured in TV factory.
2. Specification
(1) Because this is not a hot chassis, it is not necessary to
use an isolation transformer. However, the use of isolation
transformer will help protect test instrument.
(2) Adjustment must be done in the correct order.
(3) The adjustment must be performed in the circumstance of
25 °C ± 5 °C of temperature and 65±10% of relative
humidity if there is no specific designation.
(4) The input voltage of the receiver must keep 100~240V,
50/60Hz.
(5) The receiver must be operated for about 5 minutes prior to
the adjustment when module is in the circumstance of over
15 °C
- In case of keeping module is in the circumstance of 0°C, it
should be placed in the circumstance of above 15°C for 2
hours
- In case of keeping module is in the circumstance of below
-20 °C, it should be placed in the circumstance of above 15
°C for 3 hours,.
■ After RGB Full White in HEAT-RUN Mode, the receiver must
be operated prior to the adjustment.
■ Enter into HEAT-RUN MODE
1) Press the POWER ON KEY on R/C for adjustment.
2) OSD display and screen display PATTERN MODE.
● Set is activated HEAT run without signal generator in this
mode.
● Single color pattern ( WHITE ) of HEAT RUN MODE uses to
check panel.
● Caution : If you turn on a still screen more than 20 minutes
(Especially digital pattern, cross hatch pattern), an
after image may be occur in the black level part of
the screen.
3. PCB Assembly adjustment
* Caution : Using 'power on' button of the control R/C power on
TV
3.1. Download MAC Address, CI+ Key and
widevine, ESN Key
* The CI+ Key download is need for only PD32A/B/C Models.
* Connect TV SET and PC which download keys Writing
program by RS232C-Cable
(1) Start Program and Click 'start' Button to connect TV and
PC.
(2) When download succeed, you can see "OK" on the
screen.
* Each Chassis has it's own MAC Address. Please be careful
of download.
Copyright © LG Electronics. Inc. All rights reserved.
Only for training and service purposes

ADJUSTMENT INSTRUCTION

- 6 -
3.2. DFT Process
* Depend on situation, Step can be changed.
* Condition spec
Mode Volume
RF 0
3.3. Tool OPTION (MANUAL)
(1) Insert Access USB Memory Stick
(2) Press ADJ key on R/C to insert Tool OPTION
(3) On the " Tool Option ", Insert Tool Option by a number key
(4) Press the ENTER(■)
(5) Press ENTER(■) again.
(6) Select "OK to Download" by using ◄/►(VOL +/-) and
press ►(VOL +)
* PA32A
Model Name
Tool 42
option 1
50
60
Tool 42 HD
option 2
50 HD
50 FHD
60 FHD
Tool option 3
Tool option 4
Tool option 5
Tool option 6
Tool option 7
Power Off
DC On
PH6700
N/A
32806
32808
N/A
N/A
45158
45158
162
61757
6294
1609
13451
LGE Internal Use Only