Cisco HWIC-4ESW User Manual page 80

How to Configure EtherSwitch HWICs
SUMMARY STEPS
1.
2.
3.
4.
5.
6.
DETAILED STEPS
Command
Step 1
enable
Example:
Router> enable
Step 2
configure terminal
Example:
Router# configure terminal
Step 3
bridge bridge-group priority number
Example:
Router(config)# bridge 100 priority
5
Step 4
end
Example:
Router(config)# end
Step 5
show running-config
Example:
Router: show running-config
Step 6
copy running-config startup-config
Example:
Router# copy running-config
startup-config
This command does not have a no form. To return to the default setting, use the bridge bridge-group
priority number global configuration command, and set the priority to the default value. To change the
priority on an interface, use the bridge-group priority interface configuration command (described in
the next section).
Book Title
80
enable
configure terminal
bridge bridge-group priority number
end
show running-config
copy running-config startup-config
Cisco HWIC-4ESW and HWIC-D-9ESW EtherSwitch Interface Cards
Purpose
Enables privileged EXEC mode.
Enter your password if prompted.
•
Enters global configuration mode.
Changes the priority of the switch.
For bridge-group, specify the bridge group number. The range is 1
•
to 255.
• For number, enter a number from 0 to 65535. The default is 32768.
The lower the number, the more likely the switch will be chosen as
the root.
Returns to privileged EXEC mode.
Verifies your entry.
(Optional) Saves your entry in the configuration file.