Changing The Switch-To-Client Retransmission Time - Cisco HWIC-4ESW User Manual

How to Configure EtherSwitch HWICs
SUMMARY STEPS
1.
2.
3.
4.
5.
6.
DETAILED STEPS
Command or Action
Step 1
enable
Example:
Router> enable
Step 2
configure terminal
Example:
Router# configure terminal
Step 3
dot1x timeout quiet-period seconds
Example:
Router(config)#dot1x timeout quiet-period 120
Step 4
end
Example:
Router(config-if)# end
Step 5
show dot1x
Example:
Router# show dot1x
Step 6
copy running-config startup-config
Example:
Router# copy running-config startup-config
To return to the default quiet time, use the no dot1x timeout quiet-period global configuration
command.

Changing the Switch-to-Client Retransmission Time

The client responds to the EAP-request/identity frame from the switch with an EAP-response/identity
frame. If the switch does not receive this response, it waits a set period of time (known as the
retransmission time), and then retransmits the frame.
Book Title
30
enable
configure terminal
dot1x timeout quiet-period seconds
end
show dot1x
copy running-config startup-config
Cisco HWIC-4ESW and HWIC-D-9ESW EtherSwitch Interface Cards
Purpose
Enables privileged EXEC mode.
• Enter your password if prompted.
Enters global configuration mode.
Sets the number of seconds that the switch remains in the
quiet state following a failed authentication exchange with
the client.
The range is 0 to 65535 seconds; the default is 60.
•
Returns to privileged EXEC mode.
Verifies your entries.
(Optional) Saves your entries in the configuration file.