Electrical Connections - JVC KD-DV7306 Installation & Connection Manual

ELECTRICAL CONNECTIONS

A
Typical connections
Before connecting: Check the wiring in the vehicle carefully. Incorrect connection may cause serious
damage to this unit.
The leads of the power cord and those of the connector from the car body may be different in color.
VIDEO (see diagram )
SW (Subwoofer) (see diagram )
Antenna connector
LINE OUT (see diagram )
LINE IN (see diagram )
DIGITAL OUT (see diagram
White with black stripe White
Left speaker (front)
B
Connecting the parking brake wire
When installing the monitor in a location where it can be seen by the driver
Connect the parking brake wire to the parking brake system built in the car.
Parking brake
Parking brake switch
(inside the car)
When installing the monitor in a location where it cannot be seen by the driver
Connect the parking brake wire to metallic body or chassis of the car.
D
Required connections for DVD playback
or
Rear side
KV-MR9010
* 1
9-INCH WIDESCREEN MONITOR
* 1
Not supplied for this unit.
* 2
Before checking the operation of this unit prior to installation, this lead must be connected, otherwise power cannot be turned on.
*
3 To listen to disc playback sound while in Dual Zone operations (see page 28 of INSTRUCTIONS).
2nd AUDIO OUT (see diagram
15 A fuse
Rear ground terminal
To external components (see diagram
Black
* 2
Yellow
Red
Blue
Blue with white stripe
)
Orange with white stripe
Brown
Light green
Gray with black stripe Gray
Right speaker (front)
Parking brake wire (light green)
*
Signal cord 1
*
Video cord 1
KS-HP2 * 1
* 3
Cordless headphones
1
Connect the colored leads of the power cord in the order specified in the illustration below.
2
Connect the antenna cord.
3
Finally connect the wiring harness to the unit.
)
)
To metallic body or chassis of the car
To a live terminal in the fuse block connecting to the car battery
(bypassing the ignition switch) (constant 12 V)
To an accessory terminal in the fuse block
To the automatic antenna if any
(250 mA max.)
To the remote lead of other equipment (200 mA max.)
Green with black stripe Green
Left speaker (rear)
C
Connecting the crimp connector
Wire connecting the battery and
the parking brake switch.
Parking brake wire
(light green)
To metallic body or
chassis of the car
Pinch the crimp firmly.
Audio/video control amplifier or the
decoder compatible with the multichannel
digital sources
3
Ignition switch
Fuse block
To car light control switch
To cellular phone system
To parking brake, metallic body or chassis of the car
Purple with black stripe Purple
Right speaker (rear)
Attach the parking brake
wire to this point.
Contact the metallic part of the
crimp to the wires inside.
* 1
Digital optical cable