Table of Contents
Advertisement
Install the pop-up drain
Remove the plunger assembly.
plunger
Unscrew the drain outlet flange from the tee.
height adjuster
Unscrew the tailpiece from the tee. Wrap the
threads with plumbers' thread tape and replace.
Install the white, flexible sealing gasket to the
flange
flange. Place it in the sink outlet.
From under the sink, install the black mack gas-
ket, white friction ring and retainer nut to the
flange. Do not tighten the nut against the bottom
sealing gasket
of the sink at this time.
Thread the tee and tailpiece to the flange. The
mack gasket
pivot must face the faucet. If necessary, turn the
drain assembly.
friction ring
pull rod
Tighten the retainer nut.
Place the plunger assembly in the drain.
retainer nut
Install the horizontal rod so that the end goes
through the loop in the bottom of the height
adjuster.
tee
Install and hand tighten the pivot ball nut.
pivot ball nut
Attach the swivel connector to the end of the
horizontal rod.
horizontal rod
tailpiece
swivel connector
Attach the swivel connector to the end of the pull rod.
Position as desired and tighten with a small, flat bladed
screwdriver.
7
Advertisement
Table of Contents
