Fixed Head Units Additional Adjustment; Seat (Grammer Gs85/90) - Ransomes HIGHWAY 2130 Safety And Operation Manual

8 ADJUSTMENTS
GB
8.2 SPORT 200 FIXED HEAD ADDITIONAL
ADJUSTMENT
1. Accommodation for extra high height of
cut adjustment is built into the cutting unit
centre pivot.
2. By repositioning the rear centre pivot bolt
a height of cut, up to 80mm (3.2in) can be
achieved.
NOTE: When the extra height of cut is not
required the unit should be operated
with the bolt in the bottom hole.
8.3 SEAT
(GS85/90)
The seat can be adjusted for operator's weight and
leg reach to provide a comfortable position for
operating the machine.
1. ADJUSTMENT FOR OPERATOR WEIGHT
To Adjust:
The position of the adjusting knob (A) is on the front
of the seat, in the centre below the seat cushion. By
rotating the knob clockwise the weight capacity is
increased and by rotating the knob anticlockwise
the weight capacity is decreased.
2. FORE AND AFT ADJUSTMENT
To Adjust:
The position of the adjusting lever is on the right
hand side of the seat below the seat cushion (B).
By moving the lever towards the seat, the seat can
be slid backwards and forwards. When in the
desired position release the lever to locate in one of
the pre set positions.
3. BACK REST ADJUSTMENT
The back rest has three preset positions
To Adjust:
The position of the release lever is on the left hand
side of the seat back rest (C). Move the lever
upwards to move the upper part of the back rest
forward. Move the lever downwards to move the
upper part of the back rest rearwards.
NOTE:The seat is fitted with a microswitch to sense
operator presence. When the machine is fitted with
a ROPS frame or cab a lap belt is fitted and should
be worn at all times
GB-24
RANSOMES HIGHWAY 2130
SAFETY AND OPERATORS MANUAL