Quick Configuration Guide; Introduction; Configuring And Installing The Switch Module - Lucent Technologies 2300EU System Administrator Manual

Quick Configuration
This section provides step-by-step procedures to

Introduction

configure your Switch Module.
Ensure that you have the Switch Module (module is
Configuring
labeled 'Switch Module' on the cover) before proceeding.
and
Installing the
To configure and connect your ISDN DEFINITY
Switch
Extender, Models 2300EU and 2100EU, see Figure 1:
Module
PHONE/
SWITCH
Figure 1. Switch Module Back Panel
1.
2.
3.
10
RS-232
Plug the Switch
PHONE/SWITCH on the Module back plane) into
®
the DEFINITY ECS using the RJ45 cable.
Plug the Switch Module ISDN interface (labeled
ISDN) into the ISDN line provided by the
®
DEFINITY ECS or your service provider using the
RJ45 cable.
Plug the male DB9 end of the RS232 cable into the
Switch Module connector (labeled RS232) and the
other end of the RS232 cable into a PC running a
terminal emulation program or a terminal.
Continued on the next page...
ISDN DEFINITY® Extender 2300EU/2100EU
ISDN +12VDC
Module port (labeled
®