Using The System-Defined Timestamp Variable; Running A Command Script - Cisco Nexus 5500 Series Configuration Manual

Using the System-Defined Timestamp Variable

Rx
Tx
Using the System-Defined Timestamp Variable
This example uses $(TIMESTAMP) when redirecting show command output to a file:
switch# show running-config > rcfg.$(TIMESTAMP)
Preparing to copy....done
switch# dir
Usage for bootflash://sup-local
8192 bytes used
20963328 bytes free
20971520 bytes total

Running a Command Script

This example displays the CLI commands specified in the script file:
switch# show file testfile
configure terminal
interface ethernet 2/1
no shutdown
end
show interface ethernet 2/1
This example displays the run-script command execution output:
switch# run-script testfile
`configure terminal`
`interface ethernet 2/1`
`no shutdown`
`end`
`show interface ethernet 2/1 `
Ethernet2/1 is down (Link not connected)
Hardware is 10/100/1000 Ethernet, address is 0019.076c.4dac (bia 0019.076c.4dac)
MTU 1500 bytes, BW 1000000 Kbit, DLY 10 usec,
Encapsulation ARPA
Port mode is trunk
auto-duplex, auto-speed
Beacon is turned off
Auto-Negotiation is turned on
Input flow-control is off, output flow-control is off
Auto-mdix is turned on
Switchport monitor is off
Cisco Nexus 5500 Series NX-OS Fundamentals Configuration Guide, Release 7.x
74
0 input packets 0 unicast packets 0 multicast packets
0 broadcast packets 0 jumbo packets 0 storm suppression packets
0 bytes
0 output packets 0 multicast packets
0 broadcast packets 0 jumbo packets
0 bytes
0 input error 0 short frame 0 watchdog
0 no buffer 0 runt 0 CRC 0 ecc
0 overrun 0 underrun 0 ignored 0 bad etype drop
0 bad proto drop 0 if down drop 0 input with dribble
0 input discard
0 output error 0 collision 0 deferred
0 late collision 0 lost carrier 0 no carrier
0 babble
0 Rx pause 0 Tx pause 0 reset
12667 May 01 12:27:59 2008
reliability 255/255, txload 1/255, rxload 1/255
Understanding the Command-Line Interface
rcfg.2008-05-01-12.27.59
OL-30890-01