Cisco Nexus 5500 Series Configuration Manual page 40

Initial Configuration
when no configuration is present. So setup always assumes system
defaults and not the current system configuration values.
Press Enter at anytime to skip a dialog. Use ctrl-c at anytime
to skip the remaining dialogs.
Would you like to enter the basic configuration dialog (yes/no): yes
The setup utility guides you through the basic configuration process. Press Ctrl-C at any prompt to end the configuration
process.
Step 4
Enter the new password for the administrator (admin is the default).
Example:
Enter the password for admin: admin
Step 5 Enter yes (no is the default) to create additional accounts.
Example:
Create another login account (yes/no) [n]: yes
While configuring your initial setup, you can create an additional user account (in the network-admin role) besides the
administrator's account.
a) Enter the user login ID.
Example:
Enter the user login ID: user_name
b) Enter the user password.
Example:
Enter the password for user_name: user-password
Step 6
Enter yes (yes is the default) to create an SNMP read-only community string.
Example:
Configure read-only SNMP community string (yes/no) [n]:yes
SNMP community string: snmp_community
Step 7 Enter a name for the switch.
Note Starting with Cisco NX-OS Release 7.3(0)N1(1), the character limit of a switch name is increased from 32 to
63 alphanumeric characters. Also, 63 characters is the maximum length limit for setting hostname using SNMP.
The default name is switch.
Example:
Enter the switch name: switch_name
Step 8 Enter yes (yes is the default) to configure out-of-band management and enter the mgmt0 IPv4 address.
Example:
Continue with Out-of-band (mgmt0) management configuration? [yes/no]: yes
Mgmt0 IPv4 address: ip_address
Cisco Nexus 5500 Series NX-OS Fundamentals Configuration Guide, Release 7.x
24
Using the Cisco NX-OS Setup Utility
OL-30890-01