ABB Tropos 1410 Installation Manual page 22

Mount the Tropos 1410 on a metal pole
Select a mounting location. You can attach the Tropos 1410 to any pipe or pole with
1.
diameter between 1 inch and 10 inches.
Slip the flat portion of the clamp under the inner slot of the pole bracket.
2.
Use the clamp to attach the pole bracket to the pole, making sure that it is level. Depending
3.
upon the diameter of the pole, you may need to use a single small clamp, single large clamp,
or pair of large clamps joined together to reach around the pole.
4. Attach the mounting bracket of the unit to the pole bracket with two 5/16-inch machine
screws (refer to
— Insert one screw through the hole at the top of the mounting bracket to the hole at the top
— Insert the other screw through the curved slot track in the mounting bracket to the hole in
5. Level the mounting bracket by rotating the unit along the curved slot tracks. Tighten the
screws.
To continue installing the Tropos 1410, see
Tropos 1410 Installation Guide
Figure 5 for the correct orientation):
of the pole bracket.
the middle of the pole bracket just above the clamp slot.
"Connecting Power and Data Cables"
Chapter 2
on page 28.
22